Siemens PA21011M Instructions For Use Manual page 35

Installing the sliding window / balcony
accessory
The sliding window/balcony installation
accessory supplied with your appliance can
also be used (See "Description of
accessories"), Fig. 12 : a, b, c, d. This
accessory can be used for both horizontal
and vertical windows.
a
b
c
d
Instructions for Use
The accessory has two holes on the side to
fit it to the window / balcony with. The user
can secure it to the frame or wall with two
screws (not included with the accessory) to
prevent it from moving or falling out of
place, Fig. 13.
Permanent installation
Performed using the wall grommet / window
grommet accessory. See "Description of
accessories".
To expel hot air through the wall, it is
necessary to make a hole in the wall and fit
the wall grommet, Fig. 14.
Remove the diffusion sleeve and connect
the air expulsion tube to the accessory.
If permanent installation is to be performed
through the window, then it is only
necessary to use the transparent end piece
on the accessory. A 10.5-cm diameter hole
needs to be cut in the glass, Fig. 15.
Fig. 12
35
Fig. 13
Fig. 14
24 - 38 cm.
Fig. 15