Controls And Their Functions - Yamaha RX-777 Owner's Manual

FRONT PANEL
1
NATURAL SOUND
STANDBY/ON
A/B/C/D/E
PHONES
0 q
1 STANDBY/ON switch
Press this switch to turn on the power to this unit. Press it again to
turn this unit into the standby mode.
Standby mode
In this state, this unit consumes a very small quantity of power
to receive infrared-signals from the remote control transmitter.
2 Display panel
Shows various information. (For details, refer to page 4.)
3 Remote control sensor
4 MEMORY (MAN'L/AUTO FM) button
5 TUNING DOWN/UP button
Used for tuning. Press the "UP" side to tune in to higher
frequencies, and press the "DOWN" side to tune in to lower
frequencies.
6 EDIT button
This button is used to exchange the places of two preset stations
with each other.
7 FM/AM button
8 PURE DIRECT switch
Press this switch so that the indicator lights up to listen to an audio
source in the purest sound. (Refer to page 11 for details.)
9 CD DIRECT AMP switch
Press this switch so that the indicator lights up to listen to a CD
source in the purest sound. (Refer to page 11 for details.)
0 A/B/C/D/E button
Press this button to select a desired group (A–E) of preset stations.
E-2

CONTROLS AND THEIR FUNCTIONS

2
STEREO RECEIVER RX–777
1 2 3 4 5
BASS TREBLE
SPEAKERS
0 0
1 1 1 1
A B
2 2 2
3 3 3
4 4 4
— 5 5 — — 5 5
w e r
34 5 6 7 8
DOWN TUNING
MEMORY EDIT
MAN'L/AUTO FM
6 7 8
TUNING MODE REC OUT/ZONE 2
TAPE/MD
AUTO/MAN'L MONO
DVD
D-TV
BALANCE LOUDNESS
0 FLAT VCR
1 1 1
-30%
2 2 2 2 10
3 3 3 3 9
4 4 4 4 8
— L 5 5 R 5 7
6
t y u
q PHONES jack
w SPEAKERS A B switches
Set the switch A or B (or both A and B) for the speaker system
(connected to this unit) you will use.
e PRESET STATIONS buttons
Select a preset station number (1 to 8).
r Tone controls
BASS
Used to increase or decrease the low frequency response. The 0
position produces flat response.
TREBLE
Used to increase or decrease the high frequency response. The 0
position produces flat response.
t BALANCE control
Adjusts the balance of the output volume to the left and right
speakers.
y Continuously variable LOUDNESS control
Used to compensate for the human ears' loss of sensitivity to high
and low-frequency ranges at low volume.
u TUNING MODE (AUTO/MAN'L MONO) button
i REC OUT/ZONE 2 selector
Used to select an input source and supply that source directly to the
REC output terminals on the rear panel, independently of the
setting of the INPUT selector. This function allows you to record
the selected source while listening to another source.
o INPUT selector
Selects the input source that you want to listen to (and watch).
p VOLUME control
Used to raise or lower the volume level.
9
PURE
UP DIRECT
FM/AM
INPUT VOLUME
VCR · D-TV · DVD · TAPE/MD · TUNER · CD · PHONO
TUNER
28
CD
PHONO
40
60
i o
CD DIRECT
AMP
16
20 12
8
4
2
0
–dB
p