Table of Contents
Advertisement
Installing the Capture Card
You are likely to need a flat blade and /or a cross head screwdriver for the installation of the X
be useful to have these to hand before you begin.
Power down the PC (including peripherals). Switch off at the mains and disconnect all the cables connected to the
computer, noting the positions for accurate re-connection.
1.
Remove the PC cover.
2. Locate a vacant PCI Express slot (x8 or
3.
Reconnect all cables to the PC then connect HDMI cables* (not supplied), distributing the video source signal to the
HDMI connectors on the X
4. Power up the PC and commence the software installation.
How to Connect Input Sources
The X
DV-UHD2 card has two HDMI connectors, input 1 at the top and input 2 at the bottom. See Fig. 1.
TREME
Care must be taken not to damage the connectors internally by forcing cables into the card (Fig. 2).
Ensure all cables are fully inserted, failure to do so can result in cables falling out and the captured signal being lost.
* Note: It is recommended that only authentic cables, approved and certified by HDMI are used with the X
UHD2 card. When capturing 4k60p, Premium Certified cables should be used.
Certified cables have a hologram/QR coded label attached.
16) on the motherboard and remove the blanking plate (retain all screws).
X
DV-UHD2 capture card.
TREME
Fig. 1
Fig. 2
5
DV-UHD2 card; it would
TREME
DV-
TREME
Advertisement
Table of Contents
