R Balance (Balance Of The Left And Right Main Speakers); 1D Lfe/Bass Out - Yamaha HTR-5460 Owner's Manual

SET MENU
1D LFE/BASS OUT (bass out
mode)
LFE signals carry low-frequency effects when this unit
decodes a Dolby Digital or DTS signal. Low-frequency
signals are defined as 90 Hz and below.
Choices: SWFR (subwoofer), MAIN, BOTH
Initial setting: BOTH
SWFR
Select this if you use a subwoofer. The LFE signals are
directed to the subwoofer.

1D LFE/BASS OUT

SWFR
MAIN
Select this if you do not use a subwoofer. The LFE
signals are directed to the main speakers.
1D LFE/BASS OUT
SWFR
BOTH
Select this if you use a subwoofer and you want to mix
the main channel low-frequency signals with the LFE
signals.
1D LFE/BASS OUT
SWFR MAIN BOTH
Notes
• When playing a 2-channel source (CD, MD, tape, video
cassette etc.), select the BOTH position to direct low bass
signals (below 90 Hz) to the SUBWOOFER jack.
• When you select SMALL (SML) for items 1A, 1B and 1C, the
low-frequency signals (90 Hz and below) from those channels
are added to the LFE and output to the subwoofer.
38
MAIN BOTH
MAIN BOTH
1E MAIN LEVEL (main level
mode)
Change this setting if you cannot match the output level
of the center and rear speakers with the main speakers
because of the unusually high-efficiency performance of
the main speakers.
Choices: Normal, –10 dB
Initial setting: Normal
Normal
Normally select this setting.
1E MAIN LEVEL
Normal
–10 dB
Select this if you cannot match the output level of your
effect speakers with that of your main speakers when
using the test tone. This setting decreases the main
speaker output level to about one-third of the normal
level.
1E MAIN LEVEL
Normal
2 L/R BALANCE (balance of the
left and right main speakers)
Use this feature to adjust the balance of the output level
from the left and right main speakers.
Control range: 10 for L/R
Initial setting: 0
Press i to decrease the output level for the
left main speaker. Press j for the right main
speaker.
2 L/R BALANCE
L I I
• • • • • • • • • •
–/+ : Adjust
/ : Exit
Note
• The L/R BALANCE setting also applies to when headphones
are being used.
–10dB
–10dB
R
• • • • • • • • • •
0