Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for QTech WP2P Digital
Summary of Contents for QTech WP2P Digital
- Page 1 WP2P Digital User Guide WP2P Digital Version 1.7...
-
Page 2: Table Of Contents
How do the modules communicate? ......................10 STAT Indicator ............................10 Link Status Indicator ..........................10 MODE Pushbutton Switch ......................... 10 Technical Specifications ....................11 Warranty ........................12 Additional Information and Support ................12 WP2P Digital– User Guide © 2020 QTech Data Systems Ltd... - Page 3 The information in this document is subject to change without notice and does not represent a commitment on any part of QTech Data Systems Limited. While the information contained herein is assumed to be accurate, QTech Data Systems Limited assumes no responsibility for any errors or omissions.
-
Page 4: About This User Guide
About This User Guide This document provides assistance with the installation and operation of the QTech Wireless Point to Point system. Included in this document is: How to install the WP2P modules WP2P and repeater operation Device Configuration ... -
Page 5: Hardware
Australian wiring regulations require that any wiring in excess of 32 volts must be carried out or be certified by a registered electrician. Consult your local electrical installer for further guidance. WP2P Digital– User Guide © 2020 QTech Data Systems Ltd... -
Page 6: Switched Inputs
The WP2P Repeater Module operates by listening for complete and valid WP2P messages and then re- transmitting them. It can be used with both WP2P Digital and WP2P Digital & Analogue type modules simultaneously. Please refer to the WP2P Repeater User Manual for further details. -
Page 7: Preparing For Installation
Consider the use of a QTech WP2P Repeater if the terrain does not permit clear line of sight. Ensure the device is operating the latest firmware especially if the device has been in storage for some time. -
Page 8: Power Supply Notes
DC ground, which can lead to damage. Suitable cost-effective plug packs are available from QTech P/N PD5412, PD5413 & PD5414. The WP2P is over Voltage protected to 30 Volt. Voltages greater than 28 Volts DC will blow the internal 500mA fast blow fuse. -
Page 9: Radio Address (Ra)
The Channel Number is identified by the “#” on the packaging label; this example is “Channel #1”. Warning – Do not use the same channel for adjacent systems. For example, if you currently use “#1” ensure that the adjacent system is “#3” etc. WP2P Digital– User Guide © 2020 QTech Data Systems Ltd... -
Page 10: Operation Notes
MODE Pushbutton Switch Pressing the mode pushbutton will clear the error condition indication on the STAT LED. If the fault is still present then the STAT LED will redisplay the error condition. WP2P Digital– User Guide © 2020 QTech Data Systems Ltd... -
Page 11: Technical Specifications
ISM band, AS/NZS 4268 Antenna Detachable SMA Operating 915 – 928 MHz Frequency Output power 20 dBm max. →100mW Modulation GFSK Communications USB 2.00, type Mini-B connector Interface (configuration and firmware upgrades) WP2P Digital– User Guide © 2020 QTech Data Systems Ltd... -
Page 12: Warranty
QTech Data Systems Limited does not warrant the suitability of this product for any particular application as the conditions in which it is used are beyond our control. This is not withstanding warranty of merchantability. Additional Information and Support If you have problems try the following: ...
Need help?
Do you have a question about the WP2P Digital and is the answer not in the manual?
Questions and answers