HIKVISION ISD-SMG318LT-F How To Install And Configure page 2

Title: How to Install and Configure Temperature Screening
Metal Detector Door
Product: Temperature Screening Metal Detector Door
Tools needed during installation
 Tape measure or other distance measuring instruments: used to determine the distance when installing
equipment on site
 Common tools: one set of screwdriver, one set of metric Allen keys, etc.
 Computer and network cable: used for equipment setup & debugging
Precautions for site survey
 The unit is designed to operate correctly only in an indoor environment and should be located away from
any source of wind or draught, either natural or artificial such as air conditioning units. Also avoid direct
sunlight and other sources of heat such as radiators or heating vents.
 It must be used indoors to ensure that the indoor temperature is 10℃- 35℃. If the temperature range is
exceeded, the accuracy of temperature measurement cannot be guaranteed.
 Install where there is a sufficient light source for correct operation of the camera but avoid backlight,
reflections and occlusion etc.
 Thermal camera warm-up time must exceed 30 minutes to allow for self-calibration and correct operation
 A person entering the screening area from an outdoor environment should ideally be allowed to climatise to
the indoor conditions for 3-5 minutes before being screened for best results. This is due to the influence of
external temperature extremes or physical exercise immediately before screening takes place which could
cause inaccurate temperature measurement. Remove hats and lift up forehead hair for an accurate reading
of temperature.
 When measuring the skin surface temperature of the human body, a person needs to stand at a distance of
1m from the fixed temperature screening metal detector door, pass one by one, make a short stop, and face
facing the camera.
Version: v1.0 Date: 01/07/2020
Page: 2 of 16