Vector M3600V Operation Manual page 8

Wiring Instruction For Two Channel Bridge Mode
· 1 . Please push the dial switches 2, 7 to the - r ight, the other switches to the left.
The Bridge indicator In front panel will light after the device set in Bridge mode.
2. The signafwill input from Ch1 in Bridge mode, no any input from Ch2, so turn just Ch1 volume
control to- adjust the sound volume. The volume conttol of Ch2 does not work in Bridge Mode.
3. Please refer to the fig Lire below to do si9nal input wiring and output wiring to speaker system.
Wiring Instruction For Two ChannGI Bridge Mode
1. Please push the dial switches 2, 7 to the right, the other switches to the left.
T- M Bridge - i ndicator in front panel will light after the device set in Btldg!il mode.
2. The signal will input from Ch1 or Ch3 In Bridge mode, no input from Ch2or Ch4, so turn just Ch1
or Ch3 volume control to adjust the sound volume. The volume control of CH 2 does not work In
l:3ridge Mode.
3. Please refer to the figure below to do si, g nal input wiring and the output wiring to speaker system.
Pagel
CH3/CH4
Si nal@ BrMge Mode
Selection
Signal 0,
Dial Switche�
Si nal@
CH 1/CH2
Mode Seiecticn
Dial Switches