Honda CBR600F Shop Manual page 115

Crank.shaft/Transmission
NOTE
When disassembling, mark and store the disassembled parts to ensure that they are reinstalled in their original
lacations.
Determine the replacement bearing color code according to the main journal bearing selection table(page 11-4 ) .
At installation, apply molybdenum solution to the main journal bearing surface.
Requisite Service
• Crankcase separation(page 10-2)
• Crankcase assembly(page 10-6)
Procedure
Q'ty
Remarks
Removal Order
( 1) Cam chain
1
(2) Cam sprocket 1
(3) Connecting rod bearing cap nut 8
(4) Connecting rod bearing cap
4
(5)
Crankshaft 1
(6) Starter clutch needle bearing
1
Refer to page 11-5 for removal.
(7) Crankshaft main journal bearing 16
lnstallatoin Order
(7) Crankshaft main journal bearing 16
(6)
Starter clutch rieedle bearing 1
Refer to page 11-5 for installation.
(5)
Crankshaft 1 Before installing the crankshaft, position all the pistons at
Top Dead Center (TDC)to prevent the crankshaft main jour-
nals from beeing damaged with the connecting rod bolts.
(4)
Connecting rod bearing cap 4 When installing the bearing cap, be careful not to reverse
the bearing cap.
(3) Connecting rod bearing cap nut 8 NOTE
.
Before tightening, apply engine oil to the threads and
seating surface of the nut.
Tighten the nuts gradually and alternately.
(2) Cam sprocket 1 Install the cam sprocket aligning the extra wide teeth of the
crankshaft and sprocket.
( 1)
Cam chain 1
11-3