Impedance Selector Switch - Yamaha HTR-5830 Owner's Manual

■ IMPEDANCE SELECTOR switch

(U.S.A. and Canada models only)
CAUTION
Do not change the setting of the IMPEDANCE
SELECTOR switch when the unit power is switched on,
as doing so may damage the unit.
If this unit fails to turn on when STANDBY/ON is
pressed on either the front panel or remote control, the
IMPEDANCE SELECTOR switch may not be fully slid
to either position. If this is the case, slide the switch all
the way to either position when this unit is in standby
mode.
Select the switch position (upper or lower) according to
the impedance of the speakers in your system.
Switch position
Upper
Lower
Speaker
FRONT A OR B
CENTER, SURROUND
FRONT A OR B
CENTER, SURROUND
IMPEDANCE SELECTOR
FRONT A OR B:6 Ω MIN./SPEAKER
:6 Ω MIN./SPEAKER
CENTER
SURROUND :6 Ω MIN./SPEAKER
FRONT A OR B:8 Ω MIN./SPEAKER
:8 Ω MIN./SPEAKER
CENTER
SURROUND :8 Ω MIN./SPEAKER
IMPEDANCE SELECTOR switch
Impedance level
The impedance of each speaker must be 6 Ω or higher.
The impedance of each speaker must be 6 Ω or higher.
The impedance of each speaker must be 8 Ω or higher.
The impedance of each speaker must be 8 Ω or higher.
CONNECTIONS
(U.S.A. model)
19