Greenheck FGI Assembly Instructions Manual page 8

Step 10 – Install HOOD END PANEL (MALE RIB)
Lift the hood end panel (male rib) into place. Use the 1/4-20 x 1 thread rolling screws with washer (hardware kit #
417119) to attach hood end panel to the diagonal end panel supports at the holes in the hood end panel that line will
line up holes in the diagonal end panel supports.
Use four #12-14 x 1 inch self-tapping screws (hardware kit # 415450) to attach the hood panel to the hat channel.
Use four #12-11 x 5/8 sheet metal screws (hardware kit # 417467) to attach the hood panel to the hood rail
assembly.
USE PROVIDED HARDWARE KIT
# 417467 AND 415450
NO. 12-11 5/8 in.
SHEET METAL SCREW
THREAD ROLLING SCREW WITH WASHER
Figure 8
8 Fabra Hood • Form F
NO. 12-14 x 1 in.
SELF TAPPING SCREW
1/4 -20 x 1 in.
HOOD PANEL/END PANEL
ASSEMBLY
NO. 12-11 5/8 in.
SHEET METAL SCREW
®