4�2 Installing The Monitor - Carbest 47349 Manual

GB
Step 9:Check the transmitter power supply cable
First engage the hand brake and be sure the vehicle is not shifted into gear� Vehicles with
automatic transmission must be in "P" for parking lock� Turn the ignition to II but do not
start the engine! Push the button (12) to power on the monitor� If the transmitter correctly
connected, a signal will now be transmitted to the monitor when putting the car into reverse
and the monitor displays the camera's viewing range�
If no image is displayed on the monitor you may further check the camera power supply
with the hand brake engaged (or vehicle in "P" for parking lock on vehicles with automatic
trans-mission), ignition turned (II) and the vehicle in reverse with a simple test� Do not start
the engine! Completely cover the camera with both palms cupped to darken the camera
surroundings and activate the night vision sensor� Leave a slight opening between your thumbs
and look into your palms� If the camera is active, all 7 LEDs around the camera will light up
red� If the LEDs do not light up check the camera's cable and terminal connections� Also see
item 4�7 on page 26�
4.2 INSTALLING THE MONITOR
• Insert the square monitor socket on the monitor arm (10) into the designated notch at the
back of the monitor� Now slide the monitor bracket upward until it catches (see image 12)�
• Open the locknut and adjust the monitor to the desired viewing angle� Now tighten the locknut
to secure the monitor�
• Clean the area of the windshield where you would like to attach the suction cup base� Now
press the suction cup base onto the windshield and move the locking lever toward the suction
cup base�
• Now plug the monitor cable (2) into the vehicle's outlet (12 V)� Place the monitor cable so as
not to impact or jeopardize the safety of the vehicle and its passengers�
Image 12
Backup Camera System RV 4.3 | 47349
34