Installation/Operation; 4�1 Installing The Backup Camera System - Carbest 47349 Manual

GB
4.0 INSTALLATION / OPERATION
4.1 INSTALLING THE BACKUP CAMERA SYSTEM
Caution!
Due to differences in technical and design-related vehicle types, these instructions for use do
not apply to all vehicle models�
Step 1: Remove license plate
First remove the rear license plate and, if applicable, also the license plate frame
(see image 2)�
Image 2
Step 2: Hole for camera cable
Now look for an opening / drill hole near the license plate opening into the interior of the
vehicle to feed the connector cable plug of the camera (1) into the interior of the vehicle� For
added visibility and easy installation remove the interior trim near the license plate� If the
vehicle has no opening, drill a hole using an 11 mm (diameter) drill bit in the area covered by
the license plate�
Caution:
be sure there are no electrical wires or other automotive parts in the area where
you will be drilling which could be damaged!
To protect the borehole in the metal panel from corrosion the metal edges should be coated
with a suitable paint coating (e�g� automaker's touch up pen) and allow to dry adequately�
Then clip the plastic ring (8) into the borehole from the outside of the vehicle�
Step 3: Mounting the camera brackets
Mount the two camera brackets (9) and, if applicable, also the number plate frame� Be sure
the distance between the two brackets (9) is no less than 4 cm (see image 3)� The camera
may be mounted above or below the license number� Image 3 shows installation above the
license number�
Backup Camera System RV 4.3 | 47349
30