TIGMON Lauben LBNSB800WT User Manual page 11

■ If the device falls into water, disconnect the mains plug immediately.
■ Only then is it safe to retrieve the device.
DaNgEr! risk of electric shock
■ Only insert the mains plug into the wall socket after the device has been completely assembled and filled.
■ Only connect the mains plug to a properly installed and easily accessible wall socket whose voltage corresponds to the
specifications on the rating plate. The wall socket must continue to be easily accessible after the device is plugged in.
■ Ensure that the power cable cannot be damaged by sharp edges or hot points. Do not wrap the power cable around the device.
■ The device is not fully disconnected from the power supply, even after it is switched off. In order to fully disconnect it, pull out the
mains plug.
■ When using the device, ensure that the power cable cannot be trapped or crushed.
■ When removing the mains plug, always pull the plug and never the cable.
■ Disconnect the mains plug from the wall socket: if there is a fault; when the blender is not in operation; prior to each cleaning; and
during thunderstorms.
■ Do not use the device if there is visible damage to the device or the power cable.
■ In order to avoid hazards, and to comply with safety requirements, repairs to this electrical appliance or its power cord must be
carried out by our customer service. If repairs are needed, please send the appliance to our customer service department.
DaNgEr! risk of injury from cutting
■ The blade insert is sharp. To prevent injury, take special care when cleaning or emptying the jug.
■ When washing manually, the water should be sufficiently clear that you can see the blades easily.
■ The device must never be operated without the vessel.
■ Never reach into the rotating blades. Do not touch rotating parts with spoons or similar utensils. Keep long hair or loose clothing
away from rotating parts as well.
■ The blade insert continues to rotate after the device is switched off.
■ Wait for it to stop moving before you remove the working cover.
WARNING!
■ Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down completely.
■ To avoid the risk of electric shock, do not clean the appliance with water and do not immerse it in water.
■ For detailed information on cleaning the appliance, please refer to the section Cleaning and care.
■ Caution: Do not fill the chopper with liquid.
■ Care is required when pouring hot liquids into the jug in case a jet of vapour should escape from the appliance.
■ Caution: Any misuse can cause severe personal injury.
■ Disconnect the mains plug from the wall socket ..., ... when it is not supervised, ... before you assemble or disassemble the device,
and for household use only.
■ Do not allow the appliance or its power cord to touch hot surfaces or to come into contact with any heat sources.
■ Do not let the power cord hang free.
■ Do not touch any moving parts during operation, and do not insert any implements (e.g. dough spatulas or cooking spoons) into
the blender jug unless the motor has come to a complete standstill.
■ No responsibility will be accepted if damage results from improper use, or if these instructions are not complied with.
Short-time operation
■ The appliance has been designed for short-term operation only, i.e. it should not be operated continuously for more than:
60 sec. Blender
10 sec. Chopper
90 sec. Mashing potato shaft
90 sec. Whisk
Connection to the mains supply
■ Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding
CE labelling directives.
Switch off the appliance afterwards and allow the motor to
cool down before switching it on again.
DE
EN
CZ
SK
PL
HU
| 11