HERO PLEASURE+ Manual page 30

(1) Boot lamp
(h) USB charger
A USB charger (1) with a cap (2) located in
the inner rack (3) is provided in your vehicle
to charge your mobile phone safely while
riding.
1
(1) USB charger
(3) Inner rack
To connect a mobile phone charger cable, first
remove the cap from the USB charger and
then plug in the charging cable to it.
2
1
(2) Switch
3
(2) Cap
Use of non-standard USB cable may cause
damage to the mobile phones.
Hero MotoCorp
damages caused due to use of non-standard
USB cable.
Always place the device in a soft clean
•
cloth/towel to avoid any damage due to road
shocks while riding.
This port is for charging compatible USB
•
devices.
Multiple charging of USB devices have to be
•
avoided, simultaneous charging may lead to
slow or no charging.
Do not leave the USB device and USB cable
•
in the inner rack when the vehicle is parked.
Charge your device only when the engine is
•
operational/while riding. Charging the USB
2
device when the engine is "OFF" would lead
to early discharge of battery.
Do not apply any soap solution, oil or grease
•
inside the USB charger.
Any personal belongings have to be removed
•
before water washing to avoid damage.
Always keep the USB port cap closed after
•
use to prevent dust or water entry during
rains/water wash.
Do not direct water jet towards the port even
•
with cap closed to avoid any short circuit.
Always dry the area using a dry cloth or
moisture free compressed air before use.
26
will not be responsible for
CAUTION
! !
NOTE