Positioning The Appliance; Water Connection; About Power Connection - Brandy Best RED6D Instruction Manual

Positioning the Appliance

This appliance is normally used on a table or similar support. The back should rest against the
wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped
with water supply and drain hoses that can be positioned to the right or the left to facilitate proper
installation.

About Power Connection

!
WARNING!
For personal safety:
Do not use an extension cord or an adapter plug
with this appliance.
Do not cut or remove the earthing under any
circumstances .
Connection from the power cord.
Electrical Requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the appropriate power supply.
Use the required fuse 10 amp, time delay fuse or circuit breaker recommended and provide separate circuit serving
only this appliance.
!
Insure proper ground
exists before use

Water Connection

Cold Water Connection
!
WARNING!
Electrical Connection
Ensure the voltage and frequency of the power being corresponds to those
on the rating plate. Only insert the plug into an electrical socket which is
earthed properly. If the electrical socket to which the appliance must be
connected is not appropriate for the plug , replace the socket, rather than
using a adaptors or the like as they could cause overheating and burns.
Connect the cold water supply hose to a threaded 3/4(inch) connector and
make sure that it is fastened tightly in place. If the water pipes are new or
have not been used for an extended period of time, let the water run to make
sure that the water is clear and free of impurities. If this precaution is not
taken, there is a risk that the water inlet can get blocked and damage the
appliance.
Please Note: If the supplied hose cloes not fit your tap, please contact your
local plumbing supply center where adapters are available for purchase.
please close the hydrant after using.
19