Yamaha YST-SW005 Owner's Manual page 11

Using two subwoofers
Connect the speaker output terminals of the amplifier to the INPUT1 terminals of the subwoofer, and connect the OUTPUT
terminals of the subwoofer to the main speakers.
Right main
speaker
Right subwoofer
VOLUME
0 10
AUTO HIGH
STANDBY
LOW
HIGH
LOW
OFF
INPUT2
/MONO
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
POWER
ON
OFF
To AC outlet
Connecting to the INPUT1/OUTPUT terminals of the subwoofer
For connections, keep the speaker cables as short as
possible. Do not bundle or roll up the excess part of the
cables. If the connections are faulty, no sound will be heard
from the subwoofer or the speakers, or both of them. Make
sure that the + and – polarity markings of the speaker
cables are observed and set correctly. If these cables are
reversed, the sound will be unnatural and lack bass.
How to Connect:
Red: positive (+)
Black: negative (–)
HIGH CUT
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
Left subwoofer
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
Speaker output
terminals
Caution
Do not let the bare speaker wires touch each other as
this could damage the subwoofer or the amplifier, or
both of them.
1
Press and hold the terminal's tab, as shown in the figure.
2
Insert the bare wire end properly into the terminal hole.
[Remove approx. 10 mm (3/8") insulation from the
speaker cable.]
3
Release your finger from the tab to allow it to lock
securely on the cable's wire end.
4
Test the firmness of the connection by pulling lightly on
the cable at the terminal.
Left main
speaker
VOLUME
0 10
AUTO HIGH
STANDBY HIGH CUT
LOW
HIGH
LOW
OFF
INPUT2
/MONO
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
POWER
ON
OFF
To AC outlet
Amplifier
E-
7