Meade RangeView ED Addendum Sheet

27 Hubble, Irvine, CA, 92618 www.meade.com
Congratulations on the purchase of your new
RangeView
There are a few simple steps to fully assemble your new spotting scope. Follow the below instructions before use.

Attaching the Eyepiece:

1. Remove the eyepiece and spotting scope from the packaging foam.
2. Take the rubber cover off the eyepiece bottom & top of the spotting scope. Keep these covers for future use.
3. Thread the eyepiece into the spotting scope body using the knurled locking ring on the eyepiece. When fully seated,
tighten the knurled locking ring by hand until firm.
Note: If the eyepiece is not tightly seated, the zoom indicator line will not stay stationary and will rotate with the
eyepiece body. Tighten the eyepiece locking ring until firmly seated and zoom indicator does not move when
adjusting the zoom.
Knurled Locking Ring

Installing the Carry Bag:

1. Open the top flap of the bag that is secured with Velcro.
2. Unzip the long zipper on the left side so it is open fully.
3. Place the spotting scope into the bag objective lens first, making sure the mounting platform and focus knobs are
accessible through their corresponding access holes.
4. Zip up the bag and re-close the top Velcro flap when not in use.
tel: 949.451.1450 fax: 949.451.1460
™
Spotting Scope!
Zoom Indicator
Remove Dust Covers (not shown)
ED
Page | 1