Controls - Toro GREENSMASTER 3000-D Operator's Manual

mately 9 cm below the top of the fill hole.
3. If the oil level is low, slowly fill with Mobile DTE
26 or equivalent hydraulic oil until the level is cor-
rect. Do not mix oils. Install the cap.
IMPORTANT: To prevent system contamination,
clean the top of hydraulic oil containers before punc-
turing. Assure the pour spout and funnel are clean.
TIRE PRESSURE
The tires are over-inflated at the factory for shipping
purposes. Reduce the pressure to the proper levels
before starting the unit.

Controls

MOW PEDAL (Fig. 5)
Depressing the mow pedal FULLY during operation
lowers the cutting units and starts the reels. The opera-
tor need not hold the pedal down during operation.
1. Mow pedal
2. Lift pedal
3. Traction pedal
LIFT PEDAL (Fig. 5)
Depressing the lift pedal during operation stops the reels
from rotating and lifts the cutting units. The lift pedal
must be FULLY depressed until the cutting units are
fully raised and have ceased rotation.
Figure 5
4. Brake pedal
5. Parking brake button
Vary the tire pressure for the drive wheels, depending on
your turf conditions, from a minimum of 8 psi (55.2
kPa) to a maximum of 12 psi (82.7 kPa). Vary the tire
pressure for the rear wheel from a minimum of 8 psi
(55.2 kPa) to a maximum of 15 psi (103.4 kPa).
Traction on the Greensmaster can be improved with
lower tire pressure.
TRACTION PEDAL (Fig. 5)
The traction pedal has two functions; to make the
machine move forward and, also to make it move in
reverse. To move forward, depress the top of the pedal;
for reverse, depress the bottom of the pedal. Do not rest
your heel on the reverse portion of pedal during forward
operation (Fig. 5, 6).
1. Forward
Before Operating
1
2
Figure 6
2. Reverse
13