Subbase - LG Y4NV15ANLK0 Data Book

Mechanical accessories
2.5 Subbase (Optional)
The Subbase provides an enclosure for an electrical receptacle, power switch and a circuit breaker. Electrical connections
to the power supply from the unit are made inside the subbase. In addition, the subbase provides structural support to the
Wall Sleeve and to the weight of the PTAC unit .
The Subbase kit consists of two leveling legs for sleeve support and an accurate unit for leveling during installation. Also,
the subbase is pre-wired and is grounded by means of a grounding screw.
Part No.: AYSB1201B Subbase - 208/230V 20A w/o DS
AYSB1301B Subbase - 208/230V 30A w/o DS
AYSB5101 Subbase Panel
AYSB6101 Subbase - Non Electrical
Notes :
w/o DS --> without disconnect switch
w/ DS --> with disconnect switch
Leveling
Bolt
Note:
When using a subbase, the wall sleeve must be installed at a minimum height of 3 –
floor and at a minimum distance of 2 –
70
Side Extension
Panel (2)
Electrical

Subbase

Access Cover
Figure 1
3
/ inches(70mm) from a finished wall.
4
PTAC
Electrical Junction Box
Receptacle
Leveling Bolt
1
/ inches (83mm) above a finished
4
6RWU0-06A
Hole to Attach
Subbase to Sleeve (2)
Accessories