Advertisement
Features Continued..
Status LED's
The
Toyota
12V Auxiliary Power Socket has 2 status LED's which illuminate during
operation according to the following situations.
Status
LEDs
Over Current Protection
This feature protects the vehicle against excessive loads by utilising a 'smart' circuit.
The smart circuit can provide up to 15A current to any one socket. If both sockets are used
simultaneously, then a combination of 22A current can be provided. If the current limit is
exceeded, then Over Current Protection will activate and power will be cut off from both
sockets.
Example:
Scenario
Socket 1
1
14A
2
14A
3
>15A
ISSUE 1 09/07/20
Green LED will flash slowly for 20 seconds on start up to
indicate the system is operating correctly.
Green
Green LED will flash quickly for approximately five minutes before
the sockets are isolated from vehicle power due to low battery
LED
charge.
Green LED will flash slowly for
sockets have re-connected to vehicle power.
Red LED will STAY SOLID ON when the sockets detect an
excessive current draw from the connected device (e.g.
short circuit).
Red
Red LED will
exceeds 16V.
LED
Red LED will
been isolated from the vehicle due to low battery charge.
Red LED will flash slowly (once every 8 seconds) when the
system is in standby mode. This can occur when vehicle
battery is critically low or when vehicle and product have not
been used for 96 hours.
The Red and Green LED will flash
Green & Red
system is in low battery charge detection override mode.
LED
Socket 1
Socket 2
Status
8A
ON
8.5A
Disabled
Un-used
Disabled
STAY SOLID ON
double
flash quickly when the sockets have
Socket 2
Status
ON
Within product operating limits
Disabled
Combined current required by the
two devices exceeds 22A
Socket 1 device requires more
ON
than 15A
6
20 seconds
AFTER the
if the vehicle battery voltage
alternately
when the
Comments
PZQ85-75295
Hide quick links:
Advertisement
