Advertisement
Quick Links
6800 Temperature Controller Retrofit Kit (472098)
INSTALLATION ................................................................................................................ 2
WIRES IDENTIFICATION ............................................................................................... 2
WIRING .............................................................................................................................. 3
OPERATION ...................................................................................................................... 6
TROUBLESHOOTING ...................................................................................................... 7
PART LIST .......................................................................................................................... 8
Warning:
This product must be installed and serviced by a professional service technician qualified in
pool/spa heater installation and maintenance. If you do not follow these instructions exactly, a fire
or explosion may result, causing property damage, personal injury or loss of life. For additional
free copies of these instructions; call (800) 831-7133.
Attention Installer.
This manual contains important information about the installation, operation and safe use of this
product. This information should be given to the owner/operator of this equipment.
Pentair Pool Products, Inc.
1620 Hawkins Ave., Sanford, NC 27330
10951 W. Los Angeles Ave., Moorpark, CA 93021
Rev. A 4-23-02
MiniMax NT Heater Dual Voltage
Installation Instructions
Table of Contents
FOR YOUR SAFETY - READ BEFORE OPERATING
Important Notice
(919) 774-4151
•
(805) 523-2400
•
WARNING
1
P/N 472126
Advertisement
Related Manuals for Pentair Pool Products MiniMax NT 6800
Summary of Contents for Pentair Pool Products MiniMax NT 6800
-
Page 1: Table Of Contents
Attention Installer. This manual contains important information about the installation, operation and safe use of this product. This information should be given to the owner/operator of this equipment. Pentair Pool Products, Inc. 1620 Hawkins Ave., Sanford, NC 27330 (919) 774-4151 •... -
Page 2: Installation
A. INSTALLATION 1. Turn off the electrical power to the heater. 2. Open the heater’s right door. 3. Disconnect all wires from the 7800 Temperature Controller and the Ignition Module. 4. Remove the left and right doors from the heater if necessary. 5. -
Page 3: Wiring
C. WIRING NOTE First check the five terminals on your blower. If there are male terminals, please cut them and replace with female terminals, (provided in the kit). Second look at the existing wiring diagram on the left door and find out what model of the NT heater you have from top of wiring diagram. - Page 4 P/N 472126 Rev. A 4-23-02...
- Page 5 Rev. A 4-23-02 P/N 472126...
-
Page 6: Operation
D. OPERATION Dual Temperature Control System POWER (THERMOSTAT SELECT) SWITCH For convenience and economy all MiniMax NT heaters are equipped with two thermostats on the front of the heater The Pool/Off/Spa switch allows the heater to be turned off control panel; see Figure 1. when heating is not desired. -
Page 7: Troubleshooting
INDICATOR LIGHT DESCRIPTION, (cont’d.) HEAT (HEAT) SERVICE (SERVICE) The heat light is on any time the thermostat has signaled a The service light is off during normal operation of heater. call for heat which initializes the ignition safety firing circuit - The light only comes on if a problem with a control has - the light comes on to indicate successful firing of the main occurred or when the heater is first firing. -
Page 8: Part List
472126 Instruction Sheet, 6800 Retrofit Kit, NT DVSS Save These Instructions Together With Your Existing Operation & Installation Manual For Future Reference. Pentair Pool Products, Inc. 1620 Hawkins Ave., Sanford, NC 27330 (919) 774-4151 • 10951 W. Los Angeles Ave., Moorpark, CA 93021 (805) 523-2400 •...