Connections To Amplifier; Using A Banana Plug - Yamaha NS-325F Owner's Manual

Before making connections, make sure that the amplifier is switched off.
■CONNECTIONS
Loosen
Black (–)
NS-325F
(R)
SPEAKERS
R
Speakers output
terminals of the
+ –
amplifier
Amplifier or
Receiver
When using a banana plug
Banana plug
2
CONNECTIONS TO YOUR AMPLIFIER
Tighten
Red (+)
+
–
NS-325F
(L)
L
A
– +
B
3
1
• Connect the screw-type input terminals at the rear of the
speakers to the speaker output terminals of the amplifier
(or receiver) with the speaker cable.
• Connect the (+) terminals on the amplifier (or receiver)
and the speakers using one side of the cable. Connect
the (–) terminals on both components using the other
side of the cable.
• Connect one speaker to the left (marked L) terminals of
your amplifier, and another speaker to the right (marked
R) terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed polarity,
the sound will be unnatural and lack bass.
How to connect:
1 Loosen the knob.
2 Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
3 Insert the bare wire.
4 Tighten the knob and secure the cables.
Test the firmness of the connection by pulling lightly on
the cables at the terminal.
Note:
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
1
Remove the cover by pulling it toward you.
2
Tighten the terminal knob.
3
Simply insert the banana plug into the terminal.
3
E-