Digital Depth Indicator - VEXILAR FL-8 SE Owner's Manual

D D - 10 0 DI GITAL D E PT H I N DI CATO R
The DD-100 is Vexilar's first smart digital indicator display that offers both digital depth and a battery status
indicator when you push the "push to test button." The DD-100 will work with all Vexilar FL/FLX series of
flashers, including older Hondex, SI-TEX and Micronar FL-8 models. Vexilar's DD-100 gives anglers what they
®
have been asking for, "Digital Depth!"
The digital depth display will always give a depth reading as long as your Vexilar FL flasher is turned on and the
transducer is in the water. The digital depth portion of the indicator will work even if the unit is not in the correct
depth range. This will allow you to set the flasher to the best depth range. If the display is blinking or the depth
numbers are going up or down rapidly, it could be that you're over a huge school of fish or bait fish or the bottom
is irregular.
The DD-100 was designed to fit in place of the popular D-130 or T-130 battery indicators which Vexilar has been
selling for years. You can easily outfit your Pro Pack, Ultra Pack or Genz Pack with the DD-100. The DD-100 not only gives you digital depth, but
also gives you the battery status of an SLA battery by pressing the button.
The only time you will see a battery status is when you push the "push to test button." The SLA battery status is given in percentages of voltage
remaining in the battery. For example, if you push the "push to test button," and it reads 70%, that means your SLA type battery is at 12.2 volts,
100% = 12.7 volts and 0%=11.0 volts.
Current draw: 124uA (micro amps) when off and 21mA (milliamperes) when on.
Note: This is not a charge indicator. It will give only current status of an SLA battery's voltage. (Not compatible with Vexilar Lithium batteries.)
Note: Flasher must be in Normal Power Mode (not LP Mode or while using an S-Cable) to get a reliable bottom signal.
69