In-Hull Transducer Mounting - VEXILAR FL-8 SE Owner's Manual

IN - H U L L TR ANSD U CE R MO UN T I NG
Surface preparation and location are the keys to having a good sonar transducer installation that will last for years, so please take a few extra
minutes to test the location and prepare the surface area. Also, the hull temperature should be at least 60° F while performing the installation.
Select an area in your boat. Ideally, for high speed operation, you will need to place the transducer near the center of the transom area of the boat,
which is often near the drain plug. You must attach the transducer to a solid hull area; this means you cannot have double hull aluminum or a foam
layer in the fiberglass between the transducer and the water.
To Install the In-Hull Transducer
1. Prepare the surface area. It is critical you find a smooth, flat spot to place your transducer. Small ridges, bumps or even paint under the
transducer will affect the quality of the sonar signal. Your surface preparation kit comes with a Scotch-Bright
down to the base material for a secure installation. Use the pad to rough-up the face of your transducer a little. This will also aid in the long-
term quality of your installation.
2. Clean the area. Use the supplied cleaning patch of isopropyl alcohol to remove dust and dirt from
the target mounting area. Be sure to also wipe clean the face of your transducer. Let dry for a few
minutes.
3. Position the transducer. Place the transducer exactly where you want to install it. Apply the four
supplied positioning pads around the transducer. The positioning pads are needed to prevent your
transducer from drifting off the target area while the A.C.E. adhesive sets up.
4. Mix and apply the epoxy. Follow the mixing directions on the packet of A.C.E. adhesive and apply
the entire packet contents directly to the face of the transducer.
5. Install the transducer. Place the transducer into position. Press firmly and twist slightly back-and-
forth to work out any air bubbles that might have been trapped in the epoxy.
6. Installation complete. Allow the A.C.E. to dry.
pad to smooth any rough areas
®
Puck
DOWN
A.C.E.
Adhesive
Boat Hull
17