Download Print this page

G-Rack Garage Shelving Units Assembly Instructions

Download this manual

What you need

to build your rack

PART A

90cm Upright x 8

PART B

30cm Side Beam x 10

PART C

90cm Front/Back Beam x 10

PART D

30cm Beam Tie x 10

PART E

90 x 30cm MDF Boards x 5

PART F

Upright Connectors x 4

PART G

Feet x 8

PART H

Unit Connectors x 2

Page 1 What you need to build your rack PART A 90cm Upright x 8 PART B 30cm Side Beam x 10 PART C 90cm Front/Back Beam x 10 PART D 30cm Beam Tie x 10 PART E 90 x 30cm MDF Boards x 5 PART F Upright Connectors x 4 PART G...
Page 3 ASSEMBLY INSTRUCTIONSGet started on the build STEP 1 Select two half uprights (PART A). Attach plastic feet (PART G) on to the bases, and upright connectors (PART F) into the tops. Knock into place with a rubber mallet if required.
Page 4 STEP 2 Add second half upright (PART A) to the upright connector (PART F) using mallet. STEP 3 Insert a short side beam (PART B) into upright (PART A) at the required level for the lowest shelf. Knock into place with a rubber mallet if required. STEP 4 Join other end of side beam (PART B)