HPC El Pilot Assembly Replacement

Caution-
Repair must be performed by a qualified service technician.
Major Steps

Tools needed to replace or install new igniter assembly

3/8" wrench
a.
9/16" wrench
b.
5/16" nut driver
c.
d. Phillips screw driver

Removing old pilot assembly:

2) Shut off power and fuel before proceeding.
Using a 3/8" wrench to remove thermocouple.
3)
4) Release Molex plug by pulling back on the white clip
then press in the black tab then pull back and remove
plug. (Fig. 3)
a. This may difficult. Be careful not to damage the
connector.
New pilot assembly with use of transition
plate:
NOTE: The transition plate is only necessary if converting
rectangular pilot shroud with smaller pilot shroud.
See Fig. 2 for example of assembly stack up.
5) Attach transition plate to existing hole for pilot in pan
6) Slide new pilot assembly through hole of transition
plate and mount pilot assembly to plate
Hearth Products Controls Co.
EI Pilot Assembly Replacement
2
Rev. 1
Graphics/Key Points
1
1 2
Page of
Pilot
Tube
Coupler
Thermocouple
Fitting
Igniter
Molex
Plug
06232020