Outdoor Revolution Compactalite Pro Integra Annexe Instructions

Outdoor Revolution

Thank you for purchasing an Outdoor Revolution product, this product will give years

of satisfactory service if basic instructions are followed, our products are designed for

Spare poles can be purchased to replace broken poles

** Porch awnings will not be swapped because of broken poles**

Please read the following instructions carefully

TIP: Refer to the photograph to help when pitching your Annexe.

Please do not leave for your vacation without fully erecting and checking the contents of your

• • • •

annexe.

Ideally erect your annexe for some period allowing it to weather.

• • • •

Please make sure that before erecting, that you site the annexe on clear Level ground with no

• • • •

sharp objects underneath. (We recommend laying a groundsheet down to keep the annexe dry and

clean)

If you have any issues relating to pitching your annexe please contact your dealer for instructions

• • • •

before going on holiday.

Please note this annexe is designed as a 'touring' annexe and not for 'permanent pitch'

• • • •

use

(Make yourself familiar with the annexe and its parts before attempting to erect)

durability and for ease of erection

IMPORTANT PLEASE CHECK YOUR EQUIPMENT

Flysheet (or outer)

2 x steel vertical poles 1 x curved top pole

Pegs in separate bag

MODEL Compactalite Pro Integra Annexe

Table of Contents

Need help?

Do you have a question about the Compactalite Pro Integra Annexe and is the answer not in the manual?

Page 1 Outdoor Revolution MODEL Compactalite Pro Integra Annexe Thank you for purchasing an Outdoor Revolution product, this product will give years of satisfactory service if basic instructions are followed, our products are designed for durability and for ease of erection Spare poles can be purchased to replace broken poles...
Page 2 ERECTION INSTRUCTIONS. Outdoor revolution Awnings are all erected outer first Lay the outer/flysheet spread out on the ground. Slacken adjusters off on the black tapes (near the ring and pin assemblies) around the foot of the awning. Open the pole bag and lay the poles out on the ground. Take the shaped steel pole and attach the 2 legs to it.