Please Read The Following Erection Instructions Carefully - Outdoor Revolution SportAir 325 Instructions & Care Manual

PLEASE READ THE FOLLOWING ERECTION
INSTRUCTIONS CAREUFULLY
TIP: Refer to the photograph to help when pitching your SportAir 325
1. Spread the flysheet out on the
ground next to your caravan with
the cowl side laying parallel to your
vehicle.
3. Peg down the rear pads at the
back of the awning against the cara-
van using the adjustable pegging
points. This keeps the awning in
place whilst you inflate it. You may
need to re-adjust them afterwards.
2. Take the awning piping and slide it
through the caravan awning channel
until the awning is in the desired
position on the vehicle. We
recommend someone else holding the
flysheet up whilst you do this.
4. Locate the Dynamic Speed Valve.
Before inflating the AirFrame Tube
make sure the Dynamic Speed Valve
quick release button is pressed out.
This makes sure the air will be held
inside the AirFrame tube.
4
5. Next, attach the pump to the Dynamic
Speed Valve and begin to carefully inflate -
taking care that no part of the fabric is
caught anywhere.
7. Then replace the cap in to the valve
and cover with the Velcro sleeve
neatly to ensure the valve is covered.
6. Inflate the AirFrame until you can give it a
good squeeze. The tube needs to have room
inside for air to expand. Don't worry if you do
keep inflating - the Intelligent Frame will re-
lease any excess air. (Please note the Intelli-
gent Frame is set to a limit of 5.5psi before it
will release air).
8. Peg out and tension the front of the
awning. Use the adjustable pegging straps to
tension the awning as you desire. Make sure
you don't over tension the fabric. If a door
zip is too tight, release some tension before
closing, never force the zip.
5