Siemens TSi80 Series Operating Instructions Manual page 30

2x
30
S IE ME N S
3 Two beeps will be heard. When the lamp "max"
remains lit continuously, unplug the iron (very
important!).
4 Hold the iron over a sink.
Press the "clean" button (11) and shake the iron
5
until approximately one third of the water
capacity of the tank is evaporated. Boiling
water and steam will come out, carrying scale
or deposits that might be there.
6 Release "clean" button, and gently shake the
iron for some seconds.
7 Repeat steps 5 and 6 three times until the tank is
empty.
8 Plug the iron in and heat it up again until the
remaining water has evaporated. Push the
"clean" button a few more times, more to make
sure that the water tank is empty.
3"
Press the "SET" button (3) for three seconds or
9
until the "calc" lamp (4) goes off.
10 Unplug the iron and let the soleplate cool down.
Wipe the soleplate with a damp cotton cloth only.
Tip:
If the water in your area is very hard, you may use
this function approximately every two weeks without
waiting for the automatic clean warning lamp "calc"
to lash.