Toro T4240 Installation Instructions Manual page 2

1. Right rear bracket
2. Washer (5 mm)
3. Locknut (5 mm)
4. Washer (8 mm)
5. Spring washer (8 mm)
6. Screw (8 mm)
7. Indicator bulb
8. Side bulb
Installing the Number-Plate
Assembly
1. Drill 4 holes (5 mm diameter) in the frame; refer to
Figure 2 and Figure
template.
2. Secure the bracket using the self-tapping screws
2).
3. Connect the wire to the lamp.
4. Secure the wire to the upright section of the frame
using the 3 cable ties (1 cable tie to secure at the top
of the wire assembly from the lamp, a second cable
tie to the center securing wire behind the bracket and
the third cable tie to retain the wire and sleeve at the
bottom of the upright).
5. Locate the 3-pin socket through the aperture in the
rear chassis and connect the number plate wire.
3. Use the number plate as a
Figure 2
9. Screw (5 x 16 mm)
10. Rear light
11. Reflector
12. Number plate
13. Number-plate lamp
14. Self-tapping screw (6 x 16 mm)
15. Left rear bracket
Note: You can remove the rear guard plate for access.
(Figure
2
Figure 3
g206686
g206694