Chapter 5 - Servicing / Maintenance; Servicing; Engine; List Of Equipment And Accessories Required For Servicing - GEISMAR STUMEC MC3 Manual

5.1 Servicing

For servicing and repairing this equipment, appropriate training, proficiency and tooling are required.
The equipment can only be serviced and repaired by persons possessing the necessary skills and sound general knowledge in mechanical engineering.
Before any servicing operation is carried out, the engine must be stopped (leave the control in the stop position) and left until cold.
To a large extent, safety in use relies on the machine being serviced correctly.
Waste resulting from servicing and maintenance operations (fluids, filters, used rags, etc.) must be processed as per regulations in force and
environmental protection directives.
Exchange or repair all worn, damaged or missing parts, whenever there is a safety risk.

5.1.1 Engine

•
Refer strictly to the manufacturer's instructions

5.1.2 List of equipment and accessories required for servicing

The following tooling is required for carrying out servicing and maintenance operations correctly:
Standard tooling (supplied with the machine)
17 mm box spanner (Ref. 28051)
17 mm flat spanner (Ref. FJM)
13 mm flat spanner (Ref. FJX)
H36 box spanner Ref. 28052A)
Plug spanner (Ref. FVL)
This list of tooling does not exclude equipment that is normal but essential for servicing, such as: Rags, brushes, grease, etc.

5.1.3 Cleaning

Make sure that the machine is kept in as clean a condition as possible. The machine's service life and its satisfactory operation depend on the care given in
cleaning the equipment.
Clean the machine carefully with a clean rag or an air gun taking care to remove any dirt that may have been deposited on it, especially close to moving
parts. As a precaution, wear gloves systematically to avoid injuring or burning hands.
Regularly clean the chain on the tilting system.
5.1
CHAPTER 5 – SERVICING / MAINTENANCE
Servicing and maintenance tooling (non-supplied with the machine)
Flat screwdriver
10, 12, 14 and 18 mm flat spanners
3, 4, 5 and 6 mm Allen keys
Multigrip pliers
MC3_Gb_00813_101020
5.1