Advertisement
Figure 2: Thermostat Tube Mount
Install the ice machine onto the Dispenser
Follow Dispenser manufacturer's instructions for installation of adapters, deflectors or other required parts.
1. After uncrating and inspection, the ice machine is ready for installation. It is important that the machine be
installed in a location where it has enough space for proper air circulation and accessibility for service, see ice
machine installation manual.
2. Remove the front, top and both side panels for ease of
installation. The icemaker is heavy so the use of a mechanical
lift is recommended for lifting the icemaker high enough to
install on top of the dispenser.
3. Secure machine to dispenser per manufacturer instructions.
ICE Series Bin Thermostat Installation
1. Remove the control box cover and install Bin Thermostat in
control box using existing mounting holes.
2. Route the bin thermostat capillary tube thru grommet in
bottom of control box and position so it does not interfere
with any electrical or moving components.
3. Thread capillary tube thru plastic tubing until the end of
plastic tubing is approximately 24" from end of capillary tube.
4. Thread capillary tube into thermal well on Thermostat Tube
Bracket. Make sure capillary tube extends thru entire length
of thermal well. Position plastic tubing so that bottom end of
plastic tubing is against top end of thermal well.
5. Silicone top end of thermal well.
ICE Series Bin Thermostat Wiring
1. Disconnect red wire from bin fill switch and cut off terminal end. This wire will be connected to bin
thermostat
2. Pull wire back through wire ties and into control box.
3. Cut wire to appropriate Length and crimp supplied ¼" Q.C. to end of wire and connect to Bin Thermostat.
4. Use the red wire from the kit and connect the ¼" Q.C. to the Bin Thermostat and connect the other end to
the Bill Fill Switch.
9081477‐01 REV D
Figure 3: Thermostat Tube Bracket location
Figure 4: Thermostat in control box
Page 2 of 4
Advertisement
