unios LINEAR Series Manual

Aeon Flex (Mini)
Class III
24V DC
CAUTION – Must Be Installed By A Licensed Electrician
• Please make sure that during installation
the predetermined bending direction is never
changed. The product may also not be twisted.
• Aeon Flex shall not be bent sharply.
• Aeon Flex is a non-traficable luminaire.
• For installation of products, careful handling is
absolutely necessary.
• The maximum single run length of the Aeon Flex
is 8 metres.
• IP67 connectors have been included. However,
please ensure the electrical connections
maintain its IP67 rating if extending.
• Surface must be free of dust, grease, oil or
separating agents.
• The installation surface must be dry and clean.
Flex Direction
Aeon Flex may not be:
Twisted
Cleaning Instructions
Before cleaning, ensure that the Aeon Flex is turned off
and allowed to cool.
Use a damp, microfibre cloth to clean the Aeon Flex. The use of
detergents for regular maintenance is not recommended as a
deposit of detergent will be left on the surface of the emitting side.
Regular cleaning of the luminaire is strongly recommended. In
harsher conditions, it is recommended that a strict cleaning schedule
is in place to ensure no eroding chemicals are left on the surface for
long periods. Take care not to damage the surface of the luminaire.
Do not use high pressure cleaners.
Edition 10.11.17 | Product design and technical data may be subject to change
FOR WARRANTY INFORMATION VISIT UNIOS.COM/WARRANTY
Please read these installation instructions carefully before installing this luminaire. The luminaire is designed for installation in accordance with relevant
Australian Standards (AS/NSZ 3000). Installation of this luminaire must comply with local and national regulations. If luminaire is not installed
according to the instructions, the warranty for the luminaire may be void.
Power IP Rating
10 Watts/Metre 68
• Due to production, tolerances in linear expansions
of up to 5mm should be expected (in width by up to
+/- 1mm).
• Please ensure that the Aeon Flex is not installed
over the joint of 2 profiles to avoid shearing effect
which could cause a damage to the Flex PCB board
inside the fixture.
Power Supply Requirements
Power supply units used for operation should ensure
the following basic protection and safety features:
• Short-Circuit Protection
• Overload Protection
• Overheat Protection
• SELV(Safety Extra Low Voltage) Equivalent
• Best temperature for assembly is between +18°C
to 35°C.
Dropped
Material
Polyurethane
Please read instruction manual on both sides carefully before bending product.
Bent sharply
Wiring
This luminaire must be used in conjunction with a remote 24V
Constant Voltage electronic control gear. Multiple luminaires must
be wired in parallel.
Dimming
Must be used with a dimmable driver. Please refer to driver
instructions for pairing of suitable dimming system
Warranty
3 Years
Accessories
The Aeon Flex is supplied with the following basic
accessories:
• 4x Mounting clips per metre
• 3x End caps
• Additional 1x male and female IP67 connector with
200mm lead
For additional clips and/or connectors the following
accessory kits are available separately:
• Top Emitting Accessory Kit (AA002)
Incl. 20x clips and 5x end caps
• Top Emitting IP67 Accessory Kit (AA001)
Incl. 1x IP67 Male+Female connectors
Sagging/Hanging
unios.com
Page 1/2
LINEAR SERIES
Bent less than Ø 300mm
< Ø mm
ENQUIRIES
+61 8 9248 1888
sales@unios.com