Table of Contents
Advertisement
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or bystanders.
Remove the key from the switch and disconnect the spark-plug wires from the spark plugs
before you do any maintenance. Set the wires aside so that they do not accidentally contact
the spark plugs.
Pre-Maintenance
Procedures
Maintenance and Storage
Safety
•
Before repairing the machine do the following:
– Disengage the drives.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Disconnect the spark-plug wire.
•
Park the machine on a level surface.
•
Clean snow and debris from the drives, mufflers,
and engine to help prevent fires.
•
Clean up oil or fuel spills.
•
Let the engine cool before storing the machine.
•
Do not store the machine or fuel near flames or
drain the fuel indoors.
•
Do not allow untrained personnel to service the
machine.
•
Use jack stands to support the machine and/or
components when required.
•
Carefully release pressure from components with
stored energy.
•
Disconnect the battery or remove the spark-plug
wire before making any repairs. Disconnect the
negative terminal first and the positive terminal
last. Connect the positive terminal first and
negative last.
•
Keep your hands and feet away from moving
parts. If possible, do not make adjustments with
the engine running.
•
Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.
•
Never interfere with the intended function of a
safety device or reduce the protection provided
by a safety device. Check their proper operation
regularly.
•
To ensure optimum performance and continued
safety certification of the machine, use only
genuine Toro replacement parts and accessories.
Replacement parts and accessories made by
other manufacturers could be dangerous, and
such use could void the product warranty.
•
Check the parking brake operation frequently.
Adjust and service as required.
Releasing the Cushion for
Rear Access
You can release the cushion for rear access to the
machine for maintenance or adjustment.
1.
Lower the platform.
2.
Loosen the twist knobs on each side of the
machine
(Figure
1. Twist knob
3.
Remove the cushion and lower it to the platform.
4.
Perform any maintenance or adjustment on the
machine.
5.
Raise the cushion, and slide it onto the pins on
both sides of the machine.
6.
Tighten the twist knobs.
25
27).
Figure 27
2. Cushion
g032556
Advertisement
Table of Contents
