Connecting To Power; Setting Up - Yamaha MG24/14 FX Owner's Manual

Yamaha mixing console owner's manual
Table of Contents

Advertisement

Connecting to Power

(1) Be sure that the mixer's power switch is off (
(2) Connect the socket end of the power cord to the AC IN connec-
tor on the rear of the mixer.
(3) Plug the other end of the power cord into a standard household
power outlet.
Be sure to unplug the power cord from the outlet if
you are not going to use the mixer again for an
extended period, and whenever there are lightning
storms in the area.
).
(1) Before connecting to microphones and instruments, be sure
that all devices are turned off. Also be sure that all of the
mixer's channel faders and master control faders are set all the
way down.
(2) For each connection, connect one end of the cable to the rele-
vant microphone or instrument and connect the other end to the
appropriate input jack on the mixer.
N O T E
(3) Power up the devices in the following order: Peripheral devices
→ mixer → power amps (or powered speakers).
N O T E
Introduction

Setting Up

On each monaural channel, you may use either
INPUT A or INPUT B, but not both. On stereo chan-
nels that provide both a phone input jack and an
RCA-pin input jack, you may use either of these but
not both. Please connect to only one of these jacks
on each channel.
When shutting the system down, turn off the power
in the opposite order: Power amps (powered speak-
ers) → mixer → peripheral devices.
Do not block the vents. Vent holes are located on the
top, bottom, front, rear, and sides of this machine. All
vent holes must remain unblocked to prevent over-
heating.
MG32/14FX, MG24/14FX
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mg32/14fxMg24/14fx

Table of Contents