Biostar A10N-9830E User Manual page 19

XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI ownership change should
be claimed by XHCI driver.
Options: Enabled (Default) / Disabled
EHCI Hand-off
This is a workaround for OSes without EHCI hand-off support. The EHCI ownership change should
be claimed by EHCI driver.
Options: Disabled (Default) / Enabled
USB Mass Storage Driver Support
This item enables or disables USB Mass Storage Driver Support.
Options: Enabled (Default) / Disabled
USB transfer time-out
This item-out value for control, Bulk, and Interrupt transfers.
Options: 20 sec (Default) / 1 sec / 5 sec / 10 sec
Device reset time-out
This item allows you to set USB mass storage device start Unit command time-out.
Options: 20 sec (Default) / 10 sec / 30 sec / 40 sec
Device power-up delay
This item maximum time the device will take before it properly reports itself to the Host
controller. "Auto"uses default value: for a Root port it is 100 ms, for a Hub port the delay is taken
from Hub descriptor.
Options: Auto (Default) / Manual
Note
» The following items appear only when you set the Device power-up delay function to [Manual].
Device power-up delay in seconds
Delay range is 1 ~ 40 seconds, in one second increments.
Options: 5 (Default)
USB FLASH DRIVE PMAP
This item Mass storage device emulation type. 'AUTO' enumerates devices according to their
media format. Optical drives are emulated as 'CDROM' , drives with no media will be emulated
according to a drive type.
Options: Auto (Default) / Floppy / Forced FDD / Hard Disk / CD-ROM
A10N-9830E / A10N-9630E
2. Advanced Menu | 19