Selecting The Output Modes Suitable For Your Speaker System - Yamaha DDP-10 Owner's Manual

SELECTING THE OUTPUT MODES SUITABLE FOR YOUR SPEAKER SYSTEM

This unit provides you the following four functions to determine the method of distributing output signals to speakers suitable for your audio
system. When speaker connections are all completed, select a proper position on each function to make the best use of your speaker
system.
DESCRIPTION OF EACH FUNCTION
1. CENTER SPEAKER (CNTR SP)
Choices: NRML/WIDE/PHNTM
Preset position: NRML
NRML (Normal):
Select this position when you use a center speaker that is
smaller than the main speakers. In this position, low bass
signals (below 90 Hz) at the center channel are output
from the MAIN output jacks (or the SUBWOOFER output
jack if the SMALL position is selected on "3. MAIN
SPEAKER" and the SWFR position is selected on "4.
LFE/BASS OUT").
WIDE: Select this position when your center speaker is
approximately the same size as the main speakers.
PHNTM (Phantom):
Select this position when you do not have a center
speaker. The center channel sound will be output from the
left and right main speakers.
14
1. CENTER SPEAKER
2. REAR SPEAKER
3. MAIN SPEAKER
4. LFE/BASS OUT
2. REAR SPEAKER (REAR SP)
Choices: SMALL/LARGE
Preset position: SMALL
SMALL:
Select this position if your rear surround speakers do not
have a high ability for bass reproduction.
In this position, low bass signals (below 90 Hz) at the rear
surround channels are output from the SUBWOOFER
output jacks (or the MAIN output jacks if the MAIN position
is selected on "4. LFE/BASS OUT").
LARGE:
Select this position if your rear surround speakers have a
high ability for bass reproduction, or a subwoofer is
connected to the rear surround speaker in parallel.
In this position, full range signals are output from the
SURROUND output jacks.