Yamaha Clavinova CVP-900 Owner's Manual page 162

Keyboard Stand Assembly
3 Insert the pedal cord plug into the pedal
connector. Insert the plug so the arrow side faces
front (toward the keyboard).
If the plug will not go in easily, do not force it.
Double-check the orientation of the plug, then
try again.
4 Attach the cord holder on the unit as shown in
the illustration below, then use the cord holder to
affix the pedal cord.
3
4
Raising the unit to the standing position.
Use the front legs as support to raise the unit.
CAUTION
• Be careful not to pinch your fingers.
• When you raise the unit, do not hold the key cover.
5
Connect the power cord.
Left of the rear leg on the bottom of the main unit,
when viewed from front
162
CVP-900
4
6
Set the adjuster.
Rotate the adjuster until it comes in firm contact
with the floor surface.
■ After completing the assembly, please
check the following.
• Are there any parts left over?
→
Review the assembly procedure and correct any
errors.
• Is the Clavinova clear of doors and other movable
fixtures?
→
Move the Clavinova to an appropriate location.
• Does the Clavinova make a rattling noise when
you shake it?
→
Tighten all screws.
• Does the pedal box rattle or give way when you
step on the pedals?
→
Turn the adjuster so that it is set firmly against
the floor.
• Are the pedal and power cords inserted securely
into the sockets?
→
Check the connection.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the
assembly diagrams and retighten all screws.
When moving the instrument after assembly, always
hold the bottom of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper handling
can result in damage to the instrument or personal injury.
Key cover
Top portion