Advertisement
Chromoflex - Manual - English V1.5
Model ´Controlled White Stripe´
This model does not have any internal current regulator. Supply voltage is passed through and the
voltage of the power supply must match the voltage of the LED stripe.
Note: LED stripes of 10 Volts, 12 Volts and 24 Volts are offered on the market. Depending on the
cable length used LEDs might need very high currents.
LEDlight flex P14 controlled white LED stripe was exclusively developed for ChromoFlex RC CW.
Note: It is available in length of 4.03 metres on wheels.
Example:
ChromoFlex RC CW is able to switch up to 5 Amperes per channel, 10 Amperes in total.
LEDlight flex CW P14, e.g. 4 m, 1 Ampere, cool white 6.300K
LEDlight flex CW P14, e.g. 4 m, 1 Ampere, warm white 2.600K
,
~
Power supply
230V input,
~ 24V/2,5A output.
230V~
First Test
Installation is very simple when using the connectors enclosed.
At first a test is performed on the module showing warm white and cold white standing for 5 sec
each. Then a change through all shades of white is performed repeating every 30 sec.
Diagnostic LED: The modules are equipped with a small red LED. For regular operation this LED will
change every 2 seconds and flickers when data is transmitted over the bus.
User Programmes/Shades of White
ChromoFlex RC CW is equipped with 25 different shades of white. In addition there are 2
programmes existing. The first programme will begin with a change from warm white to cool white and
back in 30 sec. The other programme changes from cool white to warm white. For more details see
the manual for the Remote Control and the manual for the software of USB-Dongle
- www.barthelme.de
+
24V/2,5A
-
-3-
Rev. 03.05.2010
"Chromoflex RC CW STRIPE"
CW -
Open -
WW -
Common +
Power Supply +
Power Supply -
5 wheels max.
Subject due to technical changes
Antenna
Advertisement
