Split Mode Functions; Slow-Attach Strings; Reset; Split Point - Yamaha Clavinova CLP-555 Owner's Manual

These functions make it possible to individually set the depth of the chorus effect for the
1st and 2nd dual-mode voices ("1st" and "2nd" refer to the left and right voice selectors,
respectively). Use the [–/NO] and [+/YES] buttons to set the effect depth for the correspond-
ing voice as required. The depth range is from 0 through 20. A setting of "0" produces no
effect, while a setting of "20" produces maximum effect depth. Press the [–/NO] and [+/YES]
buttons simultaneously to recall the default setting (the default effect depth setting is different
for each voice).
In a dual mode voice combination using a strings voice and any other voice, a better
"blend" can sometimes be produced by switching the strings voice to a slow-attack variation.
Use the [–/NO] and [+/YES] buttons to turn the slow-attack variation "On" or "OFF", as
required. Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting:
"OFF".
This function resets all dual-mode functions to their default values. Press the [+/YES]
button to reset the values. "End" will appear on the display when all functions have been

reset.

After selecting "F4. Y ", press the [+/YES] button to engage the split-mode function sub-
mode, then use the [<] and [>] buttons to select the desired split mode function, as listed
below.
If the Split mode is not engaged "F4. - " will appear instead of "F4. Y " and the Split mode
functions cannot be selected. Also note that you must exit from the Function mode before the
Split mode can be engaged.
In addition to the split point setting method described on page 13, the split point can be set
via this function. Use the [–/NO] and [+/YES] buttons to set the split point as required, or
simply press the appropriate key on the keyboard: from "A-1" to "C7". Press the [–/NO] and
[+/YES] buttons simultaneously to recall the default setting: "F#2".
The Function Mode
25