Early Childhood Resources ELR-0686 Manual

Half-Circle Bench for
Reading Sectional
Model#: ELR-0686
Mount Laurel,NJ 08054 USA
www.ecr4kids.com
G
F
E
C
B
A
BEFORE ASSEMBLING, MAKE
DO NOT FULLY TIGHTEN SCREWS
SURE THERE ARE NO
UNTIL ALL SCREWS HAVE
MISSING PARTS.
BEEN LOOSELY POSITIONED.
!
PARTS LIST Adult Assembly Required. Two
adults recommended.
B
Base
(Pre-Assembled)
- Contains small parts, sharp points
C
Center Panel
and edges.
D
Center Divider
- Do not stand, sit, kneel, climb, lean
E
Back Panel
or pull on unit for support.
F
Top Shelf
- Never leave children unattended.
G
Seat Cushion
- Do not place unit near high heat or
H
moisture.
Cam(8)
- Adult Supervision Recommended.
I
Metal Dowel(8)
J
Hex Head Screw(4)
If you experience any difficulties
K with this product, please contact us
Hex Key Tool
toll free at 1-888-227-9028
(Monday through Friday,
6:00am to 4:00pm Pacific Time).
NOTE:
A Phillips Head Screwdriver
Please do not return to place
will be needed for
of purchase as Early Childhood
assembly (not included)
Resources will replace defective
parts and/or product.
1
1. Secure Center Panel(C) to Base(B) using 2 Hex Head
Screws(J) as shown. Tighten with the Hex Key Tool(K).
D
TIP!
2
2. Secure Center Divider(D) to the Base(B) using 2 Hex Head
Screws(J) as shown. Tighten with the Hex Key Tool(K).
WARNING:
Attach the Center Panel to the
Base
C
J
B
Ｘ２
J
Attach the Center Divider to the
Base
D
J
C
B
3
Attach the Back Panel
3A. Insert 2 Metal Dowels(I) into the plastic plugs inside Back
Panel(E). Tighten with a Phillips Head Screwdriver.
3B. Insert 2 Cams(H) into the large holes under Base(B). Make
sure the arrows on all Cams(H) point toward the holes in the
closest edge.
3C. Position Back Panel(E) so the attached Metal Dowels(I) enter
holes in the edge of the Base(B) as shown. Turn all Cams(H) with
a Phillips Head Screwdriver until locked onto Metal Dowels(I).
D
B
4
Attach the Top Shelf
I
Ｘ２
J
D
H
4A. Insert 6 Metal Dowels(I) into the plastic plugs located underneath
Top Shelf(F). Tighten with a Phillips Head Screwdriver.
4B. Insert 2 Cams(H) into the large holes on Center Panel(C). Insert
2 Cams(H) into the large holes on Center Divider(D). Insert 2 Cams(H)
into the large holes inside Back Panel(E) as shown. Make sure the
arrows on Cams(H) point toward the holes in the closest edges.
4C. Position Top Shelf(F) so the attached Metal Dowels(I) enter the
holes in the top edges of the Center Panel(C), Center Divider(D) and
Back Panel(E) as shown. Turn Cams(H) with a Phillips Screwdriver
until locked onto the Metal Dowels(I).
Version: ELR-0686.BR.2010.01.04
Ｘ２ Ｘ２
H I
E
C
I
H
F
Ｘ６ Ｘ６
H I
E
C
B
A