Norma Face Shield Instructions

NORMA Face Shield
Information from manufacturer NORMA Distribution Center GmbH
As per PPE Regulation (EU) 2016/425
Version: 28.05.2020
Manufacturer: NORMA Distribution Center GmbH, Unterm Ohmberg 24, 34431 Marsberg, Germany
Instructions for
1. Storage: Store the NORMA Face Shield at room temperature in a dry, closed space.
2. Use: Before placing the NORMA visor on the NORMA frame, make sure to remove the protective film,
which is applied to both sides of the shield. The protective film is coloured green on one side and is clear
on the other. Tip: A piece of tape helps to remove the protective film. Simply apply it to the edge of the
film so that the piece of tape sticks out a bit. Then, pull it off. The visor is clipped to the band by placing
the holes onto the pins. The top rear ends of the visor are inserted into the small side bands. The visor
does not have to be adjusted to the user.
We recommend using the product described above once. However, if cleaned and disinfected properly,
the product can also be used multiple times. As a precaution, we would like to point out that this
recommendation is non-binding, non-validated and non-certified. The user is responsible for verifying
which processes and measures are suitable and necessary for cleaning and disinfecting the product for
repeat use in order to meet or achieve the properties required for the intended use of the product. This
applies in particular when our products are processed, combined or used otherwise.
3. Cleaning and disinfection:
using customary agents.
4. Maintenance and inspection: Inspect the PPE before use. We recommend replacing defective PPE
(e.g. scratched visor).
The visor can be cleaned using a microfibre cloth. It can be disinfected