Subscribe to Our Youtube Channel
Related Manuals for Hunter Bolivar
Summary of Contents for Hunter Bolivar
- Page 1 Bolivar Installation Manual Model: 59644 Matte Black Fan weight ±2 lbs: 21.6 lbs (9.8 kg) ©2020 Hunter Fan Co. PG3904 r052820...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference.
- Page 3 We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Hunter Pro Tip: parts. The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component.
-
Page 4: Choosing The Right Installation Location
A little more information on Angled Mounting: For optimum performance and appearance, a longer downrod should be used with your Hunter ceiling fan when installing on high or angled ceiling. If your ceiling is angled greater than 34° you will also need an Angled Mounting Kit. -
Page 5: Installing The Ceiling Bracket
You have two options for installation. Pick which one works best for your location. Remove any existing Hunter Pro Tip: bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. The machine screws are the ones that came with your outlet box. -
Page 6: Hanging The Fan
1886 Installing the Downrod Follow below if you are using the downrod that came Hunter Pro Tip: pre-assembled in your box. Need to install a longer or shorter downrod? Check out the guide at the end of The ground wire attached to the this manual. -
Page 7: Wiring The Fan
If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician. You are going to need these: Hunter Pro Tip: Here is how to connect the wires: 4 Wire Nuts (these are in the... -
Page 8: Installing The Canopy
1886 Installing the Canopy Insert the two canopy screws found in the hardware bag. Canopy Screw Canopy Screw Lift the canopy into place so that the screw holes are aligned. Installing the Blades: Insert washers found in the hardware bag into the holes in the blades, then secure each blade to a blade iron with screws found in the hardware bag. - Page 9 1886 Assembling the Light 2 of 3 1 of 3 Light Kit Screw Light Kit Screw Insert a third light kit assembly screw, Align the keyhole slots in the top found in the hardware bag, into place of the light kit assembly with the and tighten all three screws securely.
- Page 10 1886 Installing the Pull Chains Remove and discard the plastic connectors from the ends of the short pull chains Connect the appropriate pull chain pendant to each of the short chains coming from the light kit. The fan pull chain controls the speed: from high to off.
-
Page 11: Troubleshooting
Hunter instructions, accidental damage caused by the fan owner or related parties, Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. modifications to the fan, improper or incorrectly performed maintenance or repair,... - Page 12 1886 Downrod If you need a different downrod length follow these steps: Follow steps 1-5 to remove standard downrod pipe Follow steps 6-10 to reassemble with new downrod WARNING FAN FALL HAZARD To prevent SERIOUS INJURY or DEATH: • ALWAYS follow the downrod assembly instructions exactly.
Need help?
Do you have a question about the Bolivar and is the answer not in the manual?
Questions and answers