Operation - Ryobi PMC3812K Operator's Manual

 Attach the garden hose to the open side of the T-filter
and tighten securely.
NOTE: Do not remove the strainer cap and attempt to
attach the misting tube assembly opposite the garden hose.
MOUNTING THE MISTING KIT
See Figures 10 - 11, page 9.
WARNING:
Install hanging mounts in an area where no electrical
wires, utility cables, pipes, or other obstructions are
located. Contact your local utility company or a qualified
electrician if you are unsure. Ensure hanging mounts and
misting tubes are securely installed to prevent falling
object or slippery surface hazard. Failure to follow these
instructions can result in electrical shock or other serious
personal injury.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 when using a hammer to
install the hanging mounts and misting tube. Failure to
do so could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Keep water and mist discharge pointed away from all
electrical devices to reduce the risk of electrocution or
electric shock.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
ASSEMBLY
To obtain the best spray area (mist curtain), we recommend
that the misting tube be secured to an overhead support.
Always mount in a suitable location for the misting kit away
from electrical devices and switches.
To mount the misting kit:
 Turn the hose faucet completely off and disconnect the
misting tube from the T-filter.
 Attach hanging mounts to the misting tube. A mount
should be placed on either side of the slip lock connector
with fitting.
 Using a hammer, install the hanging mounts and misting
tube.
NOTE: Be careful not to damage the misting tube during
installation.
 Reinstall the misting tube to the T-filter and ensure that
the o-ring has remained in the adaptor.
WARNING:
Ensure all components of misting kit are properly
assembled and installed prior to operation and that the
system does not leak water. Improper hose connections
and/or leaks can result in a slippery surface and create
a slip and fall hazard.

OPERATION

APPLICATIONS
You may use this product for the following purposes:
 Outdoor cooling
 Dust control
 Watering plants
WARNING:
Do not use this misting kit to spray pesticides, liquid
fertilizers, or any other chemicals. Spraying these
substances could result in serious injury to the operator
or bystanders.
5 — English