Advertisement
Fig. 1
\Function Introduction
Power Supply/ Balance Switch - the power supply button is used as balance
button as well. Press it once and the signal strength LED will flash twice and
will vibrate for a short time. Then the white LED will light which means the
pinpointer is connected and completed balance state. Press the power supply
switch for about 3 seconds. The white LED will disappear and the power supply
will turn off.
LED signal strength indication and vibration alarm - When metals are
detected, the vibration motor will begin to vibrate while the red signal
strengthen LED is light .With the probe's movement it approaches more nearby
to metal targets the vibration frequency will be higher .The signal strength LED
will light in the order of red, green, blue and white. When it lights until white the
motor vibration frequency will be highest.
Illumination LED - After the pinpointer turned on the white LED will light which
means the detector is in the work and also can use as a flashlight.
Search Probe - The built in antenna uses for transmitting and receiving
signals. A 360 ° degree of 2-3 cm in the head is the higher sensitivity detection
section.
2
Advertisement
