Table of Contents
Advertisement
Available languages
Available languages
Navion
LED Area/Site Luminaire Installation Instructions
TM
SAFETY
This fi xture must be wired in accordance with the
National Electrical Code and applicable local codes
and ordinances. Proper grounding is required to insure
personal safety. Carefully observe grounding procedure
under installation section.
WARNING
Make certain power is OFF before starting installation
or attempting any maintenance. Risk of fire/electric
shock. If not qualified, consult an electrician.
• RISK OF ELECTRIC SHOCK—Disconnect power at fuse
or circuit breaker before installing or servicing.
• RISK OF BURN—Disconnect power and allow fi xture
to cool before servicing.
• RISK OF PERSONAL INJURY—Fixture may become
damaged and/or unstable if not installed properly.
Tighten all fi xture components to their recommended
torque values. Do not lift pole into place by securing
lifting device to lighting fi xture or mounting arm.
Installation Instructions
Tools Required
Ratchet, 9/16" socket, fl at blade screw driver, electrical
wiring tools.
Installation
1.
With housing lying on a smooth, soft surface open
the access door by releasing the side latches. Door
may be removed by opening approximately 130°
and lifting off the hinge. FIG. 1
2.
Using a 9/16" socket, loosen the four (4) pipe clamp
mounting bolts enough to allow mounting arm (not
included) to slide onto leveling steps. FIG. 2
3.
Close access door. Lift the housing into place,
re-open access door, and position end of mount-
ing arm onto leveling steps so that housing is level.
Care must be taken so arm does not inadvertently
strike internal components. To avoid potential
damage to fixture, ensure housing is level both
front to back and side to side by placing level on flat
surface on top of the housing.
4.
Using a 9/16" socket tighten the four (4) pipe clamp
mounting bolts to 16-18 ft-lbs. FIG. 2
LED Area/Site Luminaire Installation Instructions IMI-812 ADH140462 www.cooperlighting.com
2
Navion
TM
IMPORTANT
Read before installing fixture. Retain for future
reference.
These instructions do not claim to cover all details or
variations in the equipment, procedure, or process
described, nor to provide directions for meeting every
possible contingency during installation, operation or
maintenance. When additional information is desired
to satisfy a problem not covered suffi ciently for user's
purpose, please contact your nearest representative.
NOTE: Specifi cations and dimensions subject to change
without notice.
WARRANTY/LIABILITY
Consult www.cooperlighting.com for current Limited
Warranty and Limitations of Liability information.
FIG. 1
Latch
Optional Photocontrol Receptacle
FIG. 2
(2) Pipe Clamps
Leveling Steps
NOTE
Door
120°
(4) Bolts
Hinge
Bird Guard
Advertisement
Table of Contents
