Setting Up Audio Streams; Installing Genelec Smart Ip Manager - Genelec 4430A Quick Setup Manual

Name Standard
PoE IEEE 802.3af-2003
PoE+ IEEE 802.3at-2009
There are several Power-over-Ethernet standards. The 4430A loudspeaker
supports the PoE+ standard but also works with the lower power PoE standard.
When the 4430A also works with lower PoE power, the duration of high SPL
output is shortened, and long continuous output signals play at smaller sound
level than when the PoE+ power level is used. Genelec recommends using PoE+
power level with 4430A.

5 SETTING UP AUDIO STREAMS

Audio stream setup is done by using Dante Controller software. Download from
https://www.audinate.com/products/software/dante-controller
4430A can receive up to two audio
channels in a stream. Assign a
channel in the Transmitters list for
each 4430A input listed in the
Receiver list.

6 INSTALLING GENELEC SMART IP MANAGER

Acoustic calibration, zone setup and loudspeaker management is done using
Genelec Smart IP Manager software. Download Smart IP Manager at
https://www.genelec.com/smart-ip-manager and follow screen instructions to
install.
Power to 4430A
13 W
25.5 W