Advertisement
Available languages
Available languages
Remote Control Features And Settings
Remote Control
8
8
3
3
4
4
1 . POWER Button
Press the POWER button on the remote control to start or stop
the unit.
2 . HEAT Button
In HEAT mode, warm air will blow out after a short period of
time due to the cold-air prevention function. When FAN is set to
AUTO mode, the heat pump automatically adjusts the fan speed
according to room temperature. The
HEAT mode.
3 . COOL Button
In COOL mode, the heat pump will blow cool air. When FAN is
set to AUTO, the heat pump automatically adjusts the fan speed
according to the room temperature. The
during COOL mode.
4 . DRY Button
DRY mode is used for dehumidification. In DRY mode, when room
temperature becomes lower than setting temperature +2°F, the
Heat Pump will run intermittently at LOW speed regardless of FAN
setting. The crossed out water droplet will be displayed during
DRY mode.
5 . SPEED Button
With each press of the SPEED button, the fan speed changes
as follows: LOW-MID-HI-AUTO. The remote control display will
show the fan icon. Hold the SPEED button for 10 seconds to go
into FAN mode. Press any other button to exit this function.
49-5000489 Rev. 1
6 . TURBO Button
7 . QUIET Button
8 . TEMP +/- Button
9 . MOTION SENSOR
1
6
7
2
5
9
will be displayed during
will be displayed
The TURBO function is used for speeding up the air flow to
highest speed in heating and cooling mode. The UI interface will
display the "TURBO" icon. Pressing the TURBO again or SPEED
button will exit the Turbo function.
The QUIET function is used for lowing the fan speed to the lowest
speed. The control will display the QUIET icon on the UI interface.
Pressing the QUIET button again or the SPEED button will exit the
QUIET function.
TEMP + : The setting temperature will increase 1°F (0.5°C) when
pressed. TEMP - : The setting temperature will decrease 1°F
(0.5°C) when pressed. The range of operating temperature is
60°F-86°F (16°C-30°C).
Press the MOTION SENSE button to activate Motion Sense
mode. Eco will be displayed on the screen. While in this mode the
unit will decrease the temperature set point 1°F (0.5°C) every 20
minutes in heat mode until it reaches 68°F (20°C) or increase the
temperature set point 1°F (0.5°C) every 20 minutes in cooling
mode until it reaches 78°F (26°C) or above. If motion sensor
detects motion in the room, it will exit the eco mode and change
the temperature or the original setpoint immediately. If the set
temperature is below 68°F (20°C) while in heating mode or 78°F
(26°C) while in cooling mode, this function will not be able to
change temperature further.
10
12
14
16
18
11
13
15
17
19
20
21
5
Advertisement
