Table of Contents
Advertisement
_3
[]
Turn the remote control over and slide the
battery compartment cover in the direction of
the arrow.
[]
Insert the batteries (AA, R06, UM-3 type)
according the polarity markings on the inside
of the battery compartment.
[]
Close the battery compartment cover.
If the remote
control
operates
only when it is close to the unit, the batteries
are weak. Replace
all the batteries
with new ones.
• Use only AA, R06 or UM-3 batteries for replacement.
• Be sure the battery polarity is correct. (See the illustration inside the battery compartment.)
• Remove the batteries if the remote control will not be used for an extended period of time.
• If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with
clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
0
0
0
................................. 0
_"_@@@
Within approximately 6 m
(20 feet)
The remote control transmits a directional infrared beam. Be
sure to aim the remote control directly at the infrared sensor
during operation. When the sensor is covered or there is a
large object between the remote control and the sensor, the
sensor cannot receive signals. The sensor may not be able to
receive signals properly when it is exposed to direct sunlight
or a strong artificial light (such as a fluorescent or strobe
light). In this case, change the direction of the light or
reposition the unit to avoid direct lighting.
• Handle the remote control with care.
• Do not spill water, tea or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or store the remote control in the following
conditions:
- high humidity or temperature such as near a heater, stove or
bath;
- dusty places; or
- extremely low temperature.
7
Advertisement
Table of Contents
