Warwick ROCKBOARD STEP UP Quick Start Manual page 2

HOW TO SET UP YOUR NEW
The RockBoard Step Up Series gives you easier access to pedals in the upper rows of the Rock-
Board. Simply attach the RockBoard Step Up to the preferred location and put the pedals on it.
Please proceed with the following steps to set up your RockBoard Step Up together with your
RockBoard Pedalboard:
•
Lay down the RockBoard Step Up with the flat surface fa-
cing down. Attach the narrow velcro strips to the areas
shown. Please make sure that you use the opposite side
of the velcro that is already located on your RockBoard
pedalboard.
•
Turn the RockBoard Step Up so that the flat surface is
facing upward. Attach the wide velcro strips to the areas
shown. Please make sure that you use the
opposite side of the velcro that is already located on your
RockBoard pedalboard.
•
Place the RockBoard Step Up in your preferred location on the RockBoard pedalboard and press
firmly.
•
Attach the opposite side of the Velcro used on the RockBoard Step Up surface to the device(s)
and push firmly but carefully on to the top surface of the RockBoard Step Up. Connect all ne-
cessary cables and your RockBoard Step Up is ready to go.
Please notice:
If you do not plan to change the location of the RockBoard Step Up, you can firmly fasten it to the Rock-
Board pedalboard with the included screws. Please put the RockBoard into the preferred location, mark
the position of the 4 fixation holes on the RockBoard and drill holes with 3 mm diameter. Put in the screws
and screw them tight.
Warwick GmbH & Co. Music Equipment KG, Gewerbepark 46, 08258 Markneukirchen / Germany
info@ roc kbo ard. de
ROCKBOARD STEP UP
I ww w.rockboard.de I w w w.fa cebook .de/wa rw ickmusicdistributio n